This command clears only frame-loss information for the given MEP in segment with given segment name.
|
segment_name |
An alpha numeric string identifying the segment name. |
N/A.
Use this command to clear only frame-loss information for the given MEP in segment with given segment name.
# clear counters cfm segment "cs2" frame-loss mep 3 # # # # sho cfm segment CFM Segment Name : cs2 Domain Name : dom2 Association : a2 MD Level : 2 Destination MAC : 00:04:96:52:a7:64 Frame Delay: DMM Transmission : Disabled Frames Transmitted : 0 Frames Received : 0 DMM Tx Interval : 10 secs DMR Rx Timeout : 50 msec Alarm Threshold : 10 % Clear Threshold : 95 % Measurement Window Size : 60 Class of Service : 6 Tx Start Time : None Min Delay : None Max Delay : None Last Alarm Time : None Alarm State : None Lost Frames : 0 Frame Loss: LMM Tx Interval : 10 secs SES Threshold : 1.000000e-02 Consecutive Available Count : 4 Measurement Window Size : 1200 Class of Service : 6 Total Configured MEPs : 1 Total Active MEPs : 1 MEP ID : 3 LMM Transmission : In Progress Transmission Mode : Continuous Frames Transmitted : 0 Frames Received : 0 Availability Status : Idle Unavailability Start Time : None Unavailability End Time : None Tx Start Time : None ----------------------------------------------------------- Total Configured Segments : 1 Total Active Segments : 1 # #
This command was first available in ExtremeXOS 15.1.
This command is available on all Universal switches supported in this document.